Only when you have prefabricated all the individual parts for assembly, sanded clean and two or three times (depending on the color) have glazed, you can start leasing. With the armchairs, first join the two sides together with the longitudinal frame to form separate frames. Preferably, by putting enough glue in the dowel holes, press the dowels of the longitudinal bars into the dowel holes of the upright legs and tighten the glued joints with clamps. Has the glue hardened?, add the swiveling backrest with only one dowel on the left and right without glue between the two side parts and the three cross frames each with glue. Then clamp the chair together on a flat plate with three servants and pay attention, that legs and lower longitudinal frames keep contact with the ground all around. Finally screw on the seat boards. Wider frame timbers are used for the table than for the armchairs. They are also connected with wooden dowels and glue. However, there is one exception: Eines der beiden Rahmenteile des Untergestells sollte anstelle von Leim mit Möbelverbindern zusammenge-fügt werden, damit man das Ganze für den Winter zerlegen kann. The table top rests loosely on a stub axle, which is in the middle of the cross of the leg at the top. Below there is a connection with threaded bolts and cap nuts. by the way, A slightly protruding wooden dowel can be inserted into the table frame to lock the swiveled table top, which engages in a hole on the underside of the plate. It is also possible to attach a rustproof fastener.
7.The side parts of the chair are glued to each frame with a center brace. For this you need three servants with a wingspan of at least 60 centimeters.
8. Then glue the two sides of the chair together with the two upper and one lower cross frame. Insert the backrest beforehand with two wooden dowels.
9. Screw on the boards of the seat flush with the outer edges. Clamped boards serve as a stop, Spacer strips guarantee uniform distances.
1.The overlays in the middle of the table frame are marked with a square and a marking gauge. Saw the falling part several times down to the mark mark.
2. Use a wide chisel and a wooden hammer to clear out the overlapping cutout. Match the whole thing to the counterpart to the sample, rework if necessary.
3. Only one frame of the leg frame can be glued with wooden dowels, so that it remains decomposable. Dowels and connecting screws hold the second frame together.
4. Knocking block and hammer are needed to assemble the tabletop. only the 9,5 cm wide frame timbers are glued, all other dowels are only dry-inserted.
120 x 120 cm is the size of the table top, which can be rotated around its central axis. If you turn them around 45 degrees from the position shown here, there's plenty of legroom for four people.
weather protection, also homemade
■ You only need a few square meters of awning fabric, to make a weatherproof protective cover for this patio set yourself. The pointed gable is supported, so water can drain away quickly.